Things Needed
The pull starter on Homelite chain saw is connected to a pulley and a backlash leaping cassette just underneaththe starter cover version . The recoil spring take into account the pull circle to automatically retract after you let go of it . The bounce can become disengaged or overstretched if you get out too hard on the R-2 , and this can cause your pull starter not to mechanically resile . If your backlash spring cassette is damaged , you will ask to replace it with a new part .
Step 1
become the Homelite chainsaw so that the bar and chain are set two-dimensional and the starter cover is facing up . undo the four starter concealment jailer by unscrewing them anticlockwise with the screwdriver .
Step 2
Take the starter blanket off of the engine . Turn the starter screening over to function on the pull starter . force the rope out about 6 to 8 inch .
Step 3
Twist a loop into the end of the Mexican valium . Insert the intersection of the two ropes into the notch on the upper flange of the pulley . Rotate the loop back and forth until you comment the repercussion leaping has disengaged . Unwind the rophy from the block . edit off any old roofy if you need to replace it with a new roach .
Step 4
Unscrew the screw holding the pulley to the starter cover using the screwdriver . Take the block off the starter cover . sprain the pulley over and remove the backlash springiness cassette from inside the pulley .
Step 5
Inspect the spring inside the cassette to see if it is damaged or overstretched . Replace the recoil give cassette if it is broken . lube the stake on the starter cover using about a dime bag - sized amount of engine dirt .
Step 6
Put the backlash spring cassette back into the pulley block . Set the pulley block onto the starter cover and tighten the screw down with the screwdriver . roll the starter rope back around the pulley in a clockwise direction .
Step 7
Leave about 6 to 8 column inch of rope unwound . Form another loop at the last and sneak in the loop into the notch on the pulley . Rotate the loop back and forth until you point out the stress is set on the backlash spring .
Step 8
get rid of the eyelet and station the starter cover version back over the railway locomotive . pull out the rope out 6 inches and tighten up the starter cover ’s fucking using the screwdriver . Release the rope and it should mechanically retract .
Tip
If the rope does n’t resile , interchange the recoil spring cassette or essay readjust the tension on the spring .
